Nissan Sentra B18 (2020-2025) Service Manual: Steering Switch Signal a Circuit
Diagnosis Procedure
Diagnosis Procedure
-
CHECK STEERING SWITCH SIGNAL A CIRCUIT
-
-
Ignition switch OFF.
-
Disconnect combination meter harness connector and combination switch (spiral cable) harness connector.
-
Check continuity between combination meter harness connector and combination switch (spiral cable) harness connector.
Combination meter
Combination switch (spiral cable)
Continuity
Connector
Terminal
Connector
Terminal
M24
33
M30
13
Yes
34
11
-
Check continuity between combination meter harness connector and ground.
Combination meter
—
Continuity
Connector
Terminal
M24
33
Ground
No
34
-
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connector.
-
Component Inspection
Component Inspection
-
CHECK STEERING SWITCH RESISTANCE
-
Check resistance between the following steering switch terminals:
-
Steering switches
Condition
Resistance (Ω)
(Approx.)
Terminals
27
25
Depress
switch.2126
Depress
switch.654
Depress OK switch.
264
Depress
switch.52
Depress
switch.134
Depress
switch.1
Is the inspection result normal?
YES >>GO TO 2.
NO >>Replace steering switch. Refer to Removal and Installation.
-
-
CHECK SPIRAL CABLE
-
Check continuity between the following combination switch (spiral cable) terminals:
Combination switch (spiral cable)
Continuity
Terminals
27
13
Yes
25
11
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace spiral cable. Refer to Removal and Installation.
-
Other materials:
Clutch. Removal and Installation
Clutch Pedal
Exploded View
Exploded View
1.
Clutch pedal
2.
Clutch master cylinder
...
Steering wheel
WARNING
Do not adjust the steering wheel while driving. Doing so may cause you
to lose control of your Nissan Sentra and could result in an accident.
Do not position the steering wheel closer to you than necessary for proper
steering control and driving comfort.
The driver’s air bag ...
Rear-facing child restraint installation using LATCH
Do not use the LATCH lower anchors if the combined weight of the child and the
child restraint exceeds 65 lbs (29.5 kg). If the combined weight is greater than
65 lbs (29.5 kg), install the child restraint using the vehicle’s seat belt instead
of the lower anchors. Always follow the child re ...