Nissan Sentra Service Manual: Shift position indicator circuit
Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
- Start the engine.
- Shift selector lever.
- Check that the selector lever position and the shift position indicator on the combination meter are identical.
Is the inspection result normal? YES >> INSPECTION END
NO >> Go to TM-240, "Diagnosis Procedure".
Diagnosis Procedure\
1.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
- Start the engine.
- Select “Data Monitor” in “TRANSMISSION”.
- Select “RANGE”.
- Shift selector lever.
- Check that selector lever position, “RANGE” on the CONSULT screen, and shift position indicator display on the combination meter are identical.
Is the check result normal? YES >> INSPECTION END
NO-1 (“RANGE” is changed but is not displayed on the shift position indicator.>>Check “Self Diagnostic Result” in “TRANSMISSION”.
NO-2 (“RANGE” and shift position indicator are different.)>>Check “Self Diagnostic Result” in “TRANSMISSION”.
NO-3 (Specific“RANGE” is not displayed on the shift position indicator.)>>Check “Self Diagnostic Result” in “METER/M&A”.
Od off indicator lamp
Component Function Check
1.CHECK OD OFF INDICATOR LAMP FUNCTION
Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection result normal?
YES ...
Shift lock system
Component Function Check
1.CHECK SHIFT LOCK OPERATION (PART 1)
Turn ignition switch ON.
Shift the selector lever to park “P” position.
Attempt to shift the selector lever to any oth ...
Other materials:
Three-way catalyst
The three-way catalyst is an emission control
device installed in the exhaust system. Exhaust
gases in the three-way catalyst are burned at
high temperatures to help reduce pollutants.
WARNING
The exhaust gas and the exhaust system
are very hot. Keep people, animals
or flammab ...
How to select piston and bearing
Description
Selection points
Selection parts
Selection items
Selection methods
Between cylinder block and
crankshaft
Main bearing
Main bearing grade (bearing
thickness)
Determined by match of cylinder
block bearing housing
grade (inner diameter of hous ...
Dtc/circuit diagnosis
U1000 can comm
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
Dtc detection logic
Note:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual can diagnostic symptoms and ...
