Nissan Sentra manuals

Nissan Sentra Service Manual: Od off indicator lamp

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / CVT: RE0F11A / Od off indicator lamp

Component Function Check

1.CHECK OD OFF INDICATOR LAMP FUNCTION

Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to TM-239, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC (TCM)

With CONSULT


  1. Turn ignition switch ON.
  2. Check “Self Diagnostic Results” in “TRANSMISSION”.

Is any DTC detected? YES >> Check DTC detected item. Refer to TM-126, "DTC Index".

NO >> GO TO 2.

2.CHECK DTC (COMBINATION METER)

Check “Self Diagnostic Results” in “METER/M&A”. With CONSULT


Check “Self Diagnostic Results” in “METER/M&A”.

Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-26, "DTC Index".

NO >> GO TO 3.

3.CHECK COMBINATION METER INPUT SIGNAL

With CONSULT


  1. Shift the selector lever to “D” position.
  2. Select “Data Monitor” in “METER/M&A”.
  3. Select “O/D OFF IND”.
  4. Check that “O/D OFF IND” turns ON/OFF when overdrive control switch is operated. Refer to MWI-20, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> GO TO 4.

4.CHECK TCM INPUT/OUTPUT SIGNAL

With CONSULT


  1. Select “Data Monitor” in “TRANSMISSION”.
  2. Select “SPORT MODE SW”.
  3. Check that “SPORT MODE SW” turns ON/OFF when overdrive control switch is operated. Refer to TM- 114, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> Check overdrive control switch circuit. Refer to TM-236, "Diagnosis Procedure".

Overdrive control switch
Component Function Check 1.CHECK SPORT INDICATOR LAMP FUNCTION Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection result normal? YES &g ...

Shift position indicator circuit
Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift selector lever. Check that the selector lever position and the shift position indicator on the ...

Other materials:

Cooling fan
Component Function Check 1.CHECK COOLING FAN FUNCTION With CONSULT Turn ignition switch ON. Perform “FAN” in “ACTIVE TEST” mode of “ENGINE” using CONSULT Check that cooling fan operates at low speed or high speed. Without CONSULT Activate IPDM E/R auto ...

Periodic maintenance
Introduction of periodic maintenance The following tables show the normal maintenance schedule. Depending upon weather and atmospheric conditions, varying road surfaces, individual driving habits and vehicle usage, additional or more frequent maintenance may be required. Periodic maintenan ...

Service data and specifications (SDS)
Wheel Alignment (Unladen*1) *1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand tools, and mats are in designated positions. *2: Since an adjustment mechanism is not included, the value of the left and right wheels (both wheels) must be used as the standard value. ...

© 2014-2026 Copyright www.nisentra.com