Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Service Data and Specifications (sds). Service Data and Specifications (sds)

Nissan Sentra B18 (2020-2025) Service Manual: Service Data and Specifications (sds). Service Data and Specifications (sds)

Service Data and Specifications (sds)

Idle Speed : Service Data

IDLE SPEED : Service Data

Transmission	Condition	Specification (Approx.)
CVT	No load* (in P or N position)	650±50 rpm
M/T	No load* (in Neutral position)	650±50 rpm

*: Under the following conditions

A/C switch: OFF
Electric load: OFF (Lights, heater fan & rear window defogger)
Steering wheel: Kept in straight-ahead position

Ignition Timing : Service Data

IGNITION TIMING : Service Data

Transmission	Condition	Specification (Approx.)
CVT	No load* (in P or N position)	3±2° BTDC
M/T	No load* (in Neutral position)	3±2° BTDC

*: Under the following conditions

A/C switch: OFF
Electric load: OFF (Lights, heater fan & rear window defogger)
Steering wheel: Kept in straight-ahead position

Calculated Load Value : Service Data

CALCULATED LOAD VALUE : Service Data

Condition	Specification
At idle	20 – 25 %
At 2,500 rpm	10 – 15 %

Mass Air Flow Sensor : Service Data

MASS AIR FLOW SENSOR : Service Data

Supply voltage

5 ± 0.25 V

Output frequency at 1.500 rpm

5,400 - 5,900 Hz*

Mass air flow (Using CONSULT or GST)

1.5 – 2.6 g/s at idle*

4.3 – 8.2 g/s at 2,500 rpm*

*: Engine is warmed up to normal operating temperature and running under no load.

 Removal and Installation

Ecm Ecm : Exploded View ECM : Exploded View 1. Bracket 2. ECM Ecm : Removal & Installation ECM : Removal & Installation CAUTION: Perform "ADDITIONAL SERVIC...

 Fuel System. Fuel System

Other materials:

Basic Inspection
Diagnosis and Repair Work Flow Work Flow Work Flow OVERALL SEQUENCE DETAILED FLOW GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment ...

Power Supply and Ground Circuit
A/c Amp. Diagnosis Procedure Diagnosis Procedure CHECK A/C AMP. GROUND CIRCUIT FOR OPEN Ignition switch OFF. Disconnect A/C amp. connector. ...

Manifold Absolute Pressure Sensor
Component Inspection Component Inspection CHECK MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR-1 Turn ignition switch OFF. Start engine and warm it up to normal operating temperature. Turn ...