Nissan Sentra Service Manual: Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch lh (driver seat) signal to the combination meter
Component function check
1. Check combination meter input signal
Select data monitor for meter/m&a and check the buckle sw monitor value.
YES >> Inspection End.
NO >> Refer to WCS-29, "Diagnosis Procedure".
Diagnosis procedure
Regarding wiring diagram information, refer to wcs-17, "wiring diagram".
1.Check combination meter input signal
- Turn ignition switch on.
- Check voltage between combination meter harness connector m24 terminal 9 and ground.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check seat belt buckle switch circuit
- Turn ignition switch OFF.
- Disconnect combination meter harness connector m24 and seat belt buckle switch lh (driver seat) harness connector b16.
- Check continuity between combination meter harness connector m24 terminal 9 and seat belt buckle switch lh (driver seat) harness connector b16 terminal 1.
- Check continuity between combination meter harness connector m24 terminal 9 and ground.
Is the inspection result normal?
Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check seat belt buckle switch ground circuit
Check continuity between seat belt buckle switch lh (driver seat) harness connector b16 terminal 2 and ground.
Is the inspection result normal? Yes >> check the seat belt buckle switch. Refer to wcs-30, "component inspection".
No >> repair or replace harness or connector.
Component inspection
1. Check seat belt buckle switch
- Turn ignition switch off.
- Disconnect the seat belt buckle switch lh (driver seat).
- Check continuity between the seat belt buckle switch lh (driver seat) terminals 1 and 2.
Is the inspection result normal? Yes >> inspection end.
No >> replace the seat belt buckle switch lh (driver seat). Refer to sr-32, "removal and installation".
Meter buzzer circuit
Description
The buzzer for warning chime system is installed in the combination
meter.
The combination meter sounds the alarm buzzer based on the signals
transmitted from various units.
...
Other materials:
Electric oil pump
Exploded View
Transaxle assembly
Electric oil pump sub harness
O-ring
Electric oil pump and motor assembly
CVT fluid
Removal and Installation
REMOVAL
Remove neighboring parts of electric oil pump.
Remove electric oil pump sub harness.
Remove electric oil pump and motor a ...
Fuel filler cap warning system
SYSTEM DIAGRAM
SYSTEM DESCRIPTION
The fuel filler cap warning system alerts the driver to the prevention of the
fuel filler being left uncapped and
malfunction occurrences after refueling, by turning ON the fuel filler cap
warning display on the combination
meter.
ECM judges a refuele ...
C1606 EPS Motor
DTC Logic
DTC DETECTION LOGIC
Dtc
Display item
Malfunction detected condition
Possible cause
C1606
EPS MOTOR
When the motor driver malfunction of EPS control
unit or EPS motor malfunction is detected.
Harness or connector
EPS motor
Eps control ...
