Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation - Seatback Striker
REMOVAL
Remove rear seat bolster (LH/RH). Refer to Removal and Installation.
Using a suitable tool, remove clips then rear seat back finisher. Refer to Exploded View.
Remove the seatback striker bolts then seatback strikers. Refer to Exploded View.
INSTALLATION
Installation is in the reverse order of removal.
Note:
-
When installing the seat back striker, tighten bolts to specification in the order shown.
Seat back striker bolt torque
: 50 N·m (5.1 kg-m, 37 ft-lb)
Removal and Installation - Seat Cushion Hook
Removal and Installation - Seat Cushion Hook
REMOVAL
Remove the
seat cushion assembly. Refer to Removal and Installation - Seat Cushion
Assembly.
Using a
suitable tool, release the ...
Removal and Installation - Seatback Hinge Bracket
Removal and Installation - Seatback Hinge Bracket
REMOVAL
Remove the
rear seatback assemblies (LH/RH). Refer to Removal and Installation - 60:40 Split
Seatback.
Remove the
seat cu ...
Other materials:
Front coil spring and strut
Exploded View
Piston rod lock nut
Strut mount insulator
Strut mount bearing
Bound bumper
Coil spring
Lower rubber seat
Strut
Steering knuckle
Front
Removal and Installation
REMOVAL
Remove the wheel and tire using power tool. Refer to WT-47, "Exploded
View&quo ...
Compression pressure
Inspection
Warm up the engine to full operating temperature.
Release fuel pressure. Refer to EC-143, "Work Procedure".
Remove ignition coil and spark plug from each cylinder. Refer to EM-46,
"Exploded View".
Connect engine tachometer (not required in use of CONSULT). ...
Rear View Camera
Removal and Installation
Removal and Installation
Removal
Remove
trunk lid finisher. Refer to Removal and Installation.
Remove
trunk lid damper bolts (A) and trunk lid damper (1).
Disconnect
the rear view camera harness connector.
Using a
suitable tool, release pa ...
