Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation. Push-Button Ignition Switch
Push-Button Ignition Switch
Removal and Installation
Removal and Installation
REMOVAL
Remove shift selector finisher using the following steps:
-
Remove the CVT shift selector knob. Refer to Removal & Installation.
-
Using a suitable tool, release clips and pawls.
: Pawl
: Metal clip - Disconnect harness connectors and remove the shift selector finisher (1).
-
M/T shift selector knob:
-
Using suitable tool (A), remove shift knob finisher (1).
-
Remove shift knob (1) as shown.
-
Using a suitable tool, release clips of shift selector finisher (1).
: Metal clip
-
Remove shift selector finisher.
Using a suitable tool release pawls
and remove push-button ignition switch (1) from shift selector finisher
(2).
|
|
: Pawl |
INSTALLATION
Installation is in the reverse order of removal.
Other materials:
Forward-facing child restraint installation using the seat belts
WARNING
The three-point seat belt with Automatic Locking Retractor (ALR) must always
be used when installing a child restraint in the Nissan Sentra.
Failure to activate and use the ALR mode will prevent the child restraint
from being properly secured. An unsecured or unstable restraint may tip ...
Reference Value
Reference Value
TERMINAL LAYOUT
PHYSICAL VALUES
Terminal No.
(Wire color)
Description
Condition
Value
...
Rear Brake Caliper Assembly
Exploded View
Exploded View
1.
Brake caliper body
2.
Slide pin
3.
Slid ...