Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation - Drum Brake
REMOVAL
Remove rear hub assembly. Refer to Removal and Installation.
Place a suitable jack under the outer end of the rear lower link to relieve the coil spring tension.
Warning:
Place a suitable jack under the outer end of the rear lower link.
CAUTION:
Do not damage the rear lower link with suitable jack.
Remove the front and rear lower link bolts from the rear knuckle.
Remove the upper arm bolt from the rear knuckle.
Remove the rear knuckle from the Nissan Sentra vehicle.
INSTALLATION
Installation is in the reverse order of removal.
-
Perform the final tightening of the parts under the unladen conditions with the tires on the ground.
Removal and Installation - Disc Brake
Removal and Installation - Disc Brake
REMOVAL
Remove rear
hub assembly. Refer to Removal and Installation.
Place a
suitable jack under the outer end of the rear lower link to relieve
...
Rear Lower Link
...
Other materials:
Ipdm-e branch line circuit
Diagnosis Procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the ipdm e/r for damage, bend and
loose connection (unit side
and connector side).
Is the inspection result normal?
Yes ...
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS ...
System
Moonroof
Moonroof : system diagram
Moonroof : system description
Moonroof system
Input/output signal chart
Moonroof operation
Moonroof motor assembly operates with the power supply that is output
from bcm while ignition switch is
on or retained power is operating.
Tilt up/ do ...
