Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation - 60:40 Split Seatback
REMOVAL
Place the rear seatback assembly in the folded down position.
Release the
hook fasteners (A) in the lower corners of the rear seatback
assembly. 
Remove the rear seatback assembly bolts (B) from the seatback hinge brackets (1), then remove the rear seatback assembly.
INSTALLATION
Installation is in the reverse order of removal.
Note:
-
When installing the rear seatback assembly, tighten bolts to specification in the order shown.
Rear seatback assembly bolt torque
: 21.1 N·m (2.2 kg-m, 16 lb-ft)
Removal and Installation - Seat Cushion Assembly
Removal and Installation - Seat Cushion Assembly
REMOVAL
Lift up the
seat cushion assembly close to the front edge (B) to release it
from the seat cushion hooks (A) (one for each side).
...
Removal and Installation - Armrest Assembly
Removal and Installation - Armrest Assembly
REMOVAL
Note:
RH shown, LH similar.
Place the
rear seatback assembly (RH) in the folded down
position.
Release the
J-hook retainer ...
Other materials:
Seat belt maintenance
To clean the seat belt webbing, apply a
mild soap solution or any solution recommended
for cleaning upholstery or carpet.
Then wipe with a cloth and allow the seat
belts to dry in the shade. Do not allow the
seat belts to retract until they are completely
dry.
If dirt builds up in t ...
P27b3-00 Control Module
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
...
Component Function Check
Component Function Check
CHECK THE ILLUMINATION OF THE EPS
WARNING LAMP
Ignition switch ON.
Check that the EPS warning lamp turns ON, then,
EPS warning lamp turns OFF a ...
