Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Disconnect the battery negative terminal. Refer to Battery Disconnect.
Remove intake manifold. Refer to Removal and Installation.
Partially remove front fender protector (RH). Refer to Exploded View — Front Fender Protector.
Remove drive belt. Refer to Removal and Installation.
Disconnect harness connector from generator.
Remove “B" terminal nut and harness.
Remove generator bolts and generator from Nissan Sentra vehicle.
INSTALLATION
Install
generator using the following procedure: Temporarily tighten bolts in the
reverse sequence shown. Torque bolts to specification in the
sequence shown. 
|
Bolts |
:25.0 N·m (2.6 kg-m, 18 ft-lb) |
Installation of remaining components is in the reverse order of removal.
CAUTION:
-
Tighten "B" terminal nut carefully and to specification. Refer to Exploded View.
Exploded View
Exploded View
1.
Generator
A.
...
Inspection
Inspection
Perform the following:
Make sure
that generator pulley does not rattle.
Make sure
that generator pulley nut is tight.
Note:
Replace generator as an assembly if
...
Other materials:
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
C161C-83
...
Compressor Does Not Operate
Diagnosis Procedure
Diagnosis Procedure
Symptom: A/C compressor does not operate.
Note:
Perform self-diagnoses with CONSULT before performing
symptom diagnosis. If DTC is detected, perform the corresponding diagnosis.
Check that refrigerant system is pro ...
Doors
When the doors are locked using one of the
following methods, the doors cannot be opened
using the inside or outside door handles. The
doors must be unlocked to open the doors.
WARNING
Always have the doors locked while
driving. Along with the use of seat belts,
this provides ...
