Nissan Sentra Owners Manual: Doors

Nissan Sentra Owners Manual / Pre-driving checks and adjustments / Doors

When the doors are locked using one of the following methods, the doors cannot be opened using the inside or outside door handles. The doors must be unlocked to open the doors.

WARNING

Always have the doors locked while driving. Along with the use of seat belts, this provides greater safety in the event of an accident by helping to prevent persons from being thrown from the vehicle. This also helps keep children and others from unintentionally opening the doors, and will help keep out intruders.
Before opening any door, always look for and avoid oncoming traffic.
Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls. Unattended children could become involved in serious accidents.

NISSAN Vehicle Immobilizer System keys

You can only drive your vehicle using the master keys which are registered to the NISSAN Vehicle Immobilizer System components in your vehicle. These keys have a transponder chip in the key head ...

Locking with key

Driver’s side The power door lock system allows you to lock or unlock all doors at the same time. Turning the key toward the front 1 of the vehicle locks all doors. Turning the key one ...

Other materials:

Precaution for Harness Repair
Solder the repair part, and wrap it with tape. [Twisted wire fray must be 110 mm (4.33 in) or less.] Do not bypass the repair point with wire. (If it is bypassed, the turnout point cannot be separated and the twisted wire characteristics are lost.) ...

P014C, P014D, P015A, P015B A/F Sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction of A/F sensor 1, this diagnosis measures response time of the A/F signal computed by ECM from the A/F sensor 1 signal. The time is compensated by engine operating (speed and load), fuel feedback control constant, and the A/F sensor 1 tem ...

Control Units and Electrical Parts
PRECAUTIONS Never reverse polarity of battery terminals. Install only parts specified for a vehicle. Before replacing the control unit, check the input and output and functions of the component parts. Do not apply excessive force when disconnecting a connector. Do not apply exce ...