Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation

Removal and Installation

REMOVAL

Close the glass lid.

Remove the front room/map lamp assembly. Refer to Removal and Installation.

Remove the moonroof motor bolts (A).

Disconnect the harness connector and remove the moonroof motor assembly (1).

CAUTION:

Do not run the removed moonroof motor assembly as a single unit.

INSTALLATION

CAUTION:

When replacing the moonroof motor assembly, be sure to perform "ADDITIONAL SERVICE WHEN REPLACING MOONROOF MOTOR ASSEMBLY". Refer to Description.

Move moonroof motor assembly laterally little by little so that the gear is completely engaged into the wire on the moonroof unit assembly, and the surfaces become parallel. Install the bolts and tighten.

CAUTION:

Before installing the motor, be sure to place the link and wire assembly in the symmetrical and fully closed position.

Note:

If necessary, insert a suitable tool into the drive key and rotate right or left slightly to assist in complete moonroof motor gear alignment.

Remainder of installation is in the reverse order of removal.

Synchronize moonroof motor assembly with moonroof unit assembly.