Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
Warning:
-
Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes.
-
Do not use air tools or electric tools for servicing the rear seat belt retractor.
-
Do not drop the seat belt retractor. Always handle it with care.
-
Always point pre-tensioner cylinder away from body when handling.
The rear seat belt pre-tensioner is serviced as part of the rear seat belt retractor. For removal and installation of the rear seat belt retractor, refer to Removal and Installation.
Other materials:
Rear suspension beam
Exploded View
Rear suspension beam
Rear suspension arm bracket
Front
Removal and Installation
NOTE:
When removing components such as hoses, tubes, lines, etc., cap or plug
openings to prevent fluid from spilling.
REMOVAL
Remove the rear wheels and tires using power tool. Ref ...
Main line between dlc and hvac circuit
Diagnosis procedure
1.Check harness continuity (open circuit)
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Disconnect the following harness connectors.
Ecm
A/C auto amp.
Check the continuity between the data link connector and the A/C ...
Exploded View
Exploded View
1.
Battery current sensor
2.
Negative battery
cable
3.
...
