Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
CAUTION:
Keep painted surface on the body or other parts free of clutch fluid. If it spills, wipe up immediately and wash the affected area with water.
Note:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
REMOVAL
Drain clutch fluid. Refer to Draining.
Press the lock pin into the bleeding connector of the CSC, and then remove clutch tube from CSC.
Release the lock pins from the connectors of the clutch damper until the pins stop, and then remove clutch tubes from clutch damper.
Release the lock pin from the connector of the clutch master cylinder until the pin stops, and then remove clutch tube from clutch master cylinder.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not damage clutch tube.
-
Insert each clutch tube into the CSC bleeding connector, the clutch damper connector, and the clutch master cylinder connector until it contacts the end of each connector.
-
Install each lock pin into the clutch damper connector and the clutch master cylinder connector until it contacts the end of each connector.
Hydraulic Layout
Hydraulic Layout
1.
Clutch tube
2.
...
Inspection and Adjustment
Inspection and Adjustment
INSPECTION AFTER REMOVAL
Check the clutch tube for cracks and damage. If
the clutch tube has cracks or damage, replace it with a new
one.
...
Other materials:
When Rear Power Window Switch Lh Is Operated
Diagnosis Procedure
Diagnosis Procedure
CHECK REAR POWER WINDOW SWITCH LH
POWER SUPPLY AND GROUND CIRCUIT
Check rear power window switch LH power supply
and ground circuit.
Refer to Diagnosis Procedure.
Is ...
Steering column
Inspection
STEERING COLUMN ASSEMBLY
Check each part of steering column assembly for damage or
other malfunctions. Replace entire steering column
assembly if any parts are damaged.
Measure steering column rotating torque using Tool. Replace
steering column assembly if outside the ...
Vents
Adjust air flow direction by moving the vent
slides.
Open or close the vents by using the dial. Move
the dial toward the to open the
vents or
toward the to close them.
...
