Nissan Sentra B18 (2020-2025) Service Manual: Rear Regulator
Exploded View
Exploded View
|
1. |
Door glass rubber run |
2. |
Rear door panel |
3. |
Door glass |
|
4. |
Door glass regulator |
5. |
Rear power window motor |
6. |
Door glass rear run |
|
7. |
Partition glass |
Removal and Installation
Removal and Installation
Note:
RH rear door panel shown; LH side similar
REMOVAL
Remove the rear door finisher. Refer to Removal and Installation.
Remove the vapor barrier.
CAUTION:
Use care to not damage or tear vapor barrier during removal.
Temporarily
reconnect the rear power window switch to raise/lower the rear door
glass until the rear door regulator to glass bolts (A) can be
seen. 
Remove the rear door regulator to glass bolts.
Raise up
the rear door glass and hold with a suitable tool (A).
Disconnect the harness connector from the rear door glass regulator.
Loosen bolt
(A) and remove bolts (B). 
Remove the door glass regulator.
INSPECTION AFTER REMOVAL
Check the rear door glass regulator for the following items:
-
Gear wear
-
Door glass regulator deformation
-
Spring damage
-
Grease condition for each sliding part
If a malfunction is detected, replace or grease it using multi-purpose grease as shown.
If malfunction is detected, replace or grease it using multi-purpose grease as shown.
INSTALLATION
Installation is in the reverse order of removal.
Other materials:
Engine Mounting Insulator (rh)
Exploded View
Exploded View
CVT Models
1.
Engine mounting
insulator (LH)
2.
Engine mounting
insula ...
Power Supply, Ground & Circuit Elements. Basic Inspection
Battery
How to Handle Battery
How to Handle Battery
CAUTION:
If it becomes necessary to start the engine with
a booster battery and jumper cables, use a 12-volt booster
battery.
After connecting battery cables, ensure that they
...
Brake Booster
Exploded View
Exploded View
1.
Brake booster
2.
Vacuum sensor
3.
Space ...