Exploded View
|
1. |
Rear combination lamp |
2. |
Stop/tail lamp bulb |
3. |
Rear combination lamp harness |
|
4. |
Turns signal lamp bulb |
A. |
Grommet |
Disassembly and Assembly
DISASSEMBLY
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
CAUTION:
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc. may affect the performance of the lamp.
Remove rear combination lamp (body side). Refer to Removal and Installation.
Rotate rear turn signal lamp bulb socket counterclockwise to remove from rear combination lamp (body side).
Remove the rear turn signal lamp bulb from bulb socket.
Rotate stop/tail lamp bulb socket counterclockwise to remove from rear combination lamp (body side).
Remove the stop/tail lamp bulb from bulb socket.
If necessary, compress grommet as
shown and slide down to remove. 
ASSEMBLY
Assembly is in the reverse order of disassembly.
Rear Combination Lamp (trunk Lid Side)System
Headlamp system
HEADLAMP SYSTEM : System Diagram
HEADLAMP SYSTEM : System Description
LOW BEAM OPERATION
When the lighting switch is in 2nd position, the BCM receives input
requesting the headlamps to illuminate.
This input is communicated to the IPDM E/R across the CAN communication l ...
Component parts
Component Parts Location
Driver air bag module
Front passenger air bag off indicator
Front passenger air bag module
Front LH side air bag module
(RH similar)
LH side curtain air bag module
(view with headliner removed)
(RH similar)
Front LH seatbelt pre-tensioner
(view wit ...
List of Ecu Reference
List of ECU
Reference
ECU
Reference
BCM
Values on the Diagnosis Tool
Reference Value ...