Nissan Sentra B18 (2020-2025) Service Manual: Rear Combination Lamp (body Side)
Exploded View
|
1. |
Rear combination lamp |
A. |
Grommet |
B. |
Clip |
|
C. |
Grommet |
Removal and Installation
Removal
Partially remove trunk side finisher. Refer to Removal and Installation.
Remove the rear combination lamp nuts.
Disconnect the harness connector from the rear combination lamp.
Pull the rear combination lamp rearward and remove.
Installation
Installation is the reverse order of removal.
Bulb Replacement
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
CAUTION:
-
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
-
Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc. may affect the performance of the lamp.
REAR TURN SIGNAL LAMP BULB
Removal
Remove the rear combination lamp. Refer to Removal and Installation.
Rotate the rear turn signal lamp bulb socket counterclockwise and remove.
Remove the rear turn signal lamp bulb from bulb socket.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.
STOP/TAIL LAMP BULB
Removal
Remove the rear combination lamp. Refer to Removal and Installation.
Rotate the stop/tail lamp bulb socket counterclockwise and remove.
Remove the stop/tail lamp bulb from bulb socket.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.
License Plate Lamp
Exploded View
Exploded View
1.
License plate
lamp
...
Rear Combination Lamp (trunk Lid Side)
Exploded View
Exploded View
1.
Trunk lid
...
Other materials:
Continuously Variable Transmission (CVT) (if so equipped)
WARNING
Do not depress the accelerator pedal
while shifting from P (Park) or N (Neutral)
to R (Reverse), D (Drive) or L (Low).
Always depress the brake pedal until
shifting is completed. Failure to do so
could cause you to lose control and
have an accident.
Col ...
Changing engine oil filter
Park the vehicle on a level surface and apply
the parking brake.
Turn the engine off.
Place a large drain pan under the oil filter C .
Loosen the oil filter with an oil filter wrench
by turning it counterclockwise. Then remove
the oil filter by turning it by hand.
CAUTION
Be c ...
P0447 EVAP Canister vent control valve
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0447
VENT CONTROL VALVE
(Evaporative emission system vent
control circuit open)
An improper voltage signal is sent to
ECM throug ...
