Nissan Sentra B18 (2020-2025) Service Manual: Rear Axle :: Removal and Installation. Rear Wheel Hub
Rear Wheel Hub
Exploded View — with Drum Brake
|
1. |
Brake assembly |
2. |
Rear Knuckle |
3. |
Wheel stud |
|
4. |
Brake Drum |
5. |
Wheel hub assembly (Bearing-integrated type) |
Removal and Installation — with Drum Brake
REMOVAL
Remove rear brake drum. Refer to Removal and Installation.
CAUTION:
Do not depress brake pedal while rear brake drum is removed.
Remove the rear wheel sensor. Refer to Exploded View.
Remove the hub bolts and wheel hub assembly.
CAUTION:
Do not remove parking brake assembly. Protect it from falling.
INSTALLATION
Installation is in the reverse order of removal.
-
Check that the wheel hub assembly operates smoothly
-
Perform inspection after installation. Refer to Inspection.
Exploded View - Without Drum Brake
|
1. |
Rear knuckle |
2. |
Wheel stud |
3. |
Disc rotor |
|
4. |
Wheel hub assembly (Bearing-integrated type) |
5. |
Back plate |
Removal and Installation - Without Drum Brake
REMOVAL
Remove the rear brake caliper assembly and disc rotor. Refer to Removal and Installation.
CAUTION:
Do not depress brake pedal while rear brake assembly is removed.
Remove the rear wheel sensor bolt and the rear wheel sensor. Refer to Exploded View.
Remove the hub bolts and wheel hub assembly.
CAUTION:
Do not remove parking brake assembly. Protect it from falling.
INSTALLATION
Installation is in the reverse order of removal.
-
Align the matching marks that have been made during removal when reusing the disc rotor.
-
Check that the wheel hub assembly operates smoothly.
-
Perform inspection after installation. Refer to Inspection.
Inspection
INSPECTION AFTER REMOVAL
Check the wheel hub assembly for wear, cracks, and damage.
Replace if necessary.
INSPECTION AFTER INSTALLATION
Check wheel sensor harness for proper connection. Refer to Exploded View.
Other materials:
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 2,500 rpm under no load (for example, the
selector lever position is neutral and
engine speed is over 2,500 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
b ...
Moonroof switch
Description
Transmits switch operation signal to moonroof motor assembly.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to RF-13, "Wiring Diagram".
1.Check moonroof switch input signal
Turn ignition switch on.
Check voltage between moonroof motor assembly harne ...
Brake Pedal Position Switch
Component Function Check
Component Function Check
CHECK BRAKE PEDAL POSITION SWITCH
FUNCTION
With CONSULT
Turn ignition switch ON.
Select “BRAKE SW” in
“DATA MONITOR” mode of
“ENGIN ...