Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual: Park/neutral Position Switch

Component Inspection

Component Inspection

  1. CHECK PARK/NEUTRAL POSITION SWITCH-1

    1. Turn ignition switch ON.

    2. Check the voltage between ECM harness connector and ground.

      ECM

      Condition

      Voltage

      +

      -

      connector

      Terminal

      connector

      Terminal

      F24

      15

      E16

      162

      Selector lever

      P or N

      12V

      Other than above

      0V

    Is the inspection result normal?

    YES >>

    INSPECTION END

    NO >>

    GO TO 2.

  2. CHECK PARK/NEUTRAL POSITION SWITCH-2

    1. Remove park/neutral position switch. Refer to Removal and Installation.

    2. Check park/neutral position switch. Refer to Inspection.

    Is the inspection result normal?

    YES >>

    INSPECTION END

    NO >>

    Replace park/neutral position switch. Refer to Removal and Installation.

    On Board Refueling Vapor Recovery (orvr)
    Component Function Check Component Function Check CHECK ORVR FUNCTION Check whether the following symptoms are present. Fuel odor from EVAP canister is strong. Cannot refuel/Fue...
    Power Supply and Ground Circuit (ecm)
    Diagnosis Procedure Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. Note: Check the continuity between the b...

    Other materials:

    Precautions when starting and driving
    WARNING Do not leave children or adults who normally require assistance unattended in your Nissan Sentra. Pets should also never be left alone inside the vehicle. They could accidentally injure themselves or others through unintended operation of vehicle controls. In addition, on ho ...

    Body Sealing
    Description Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffecte ...

    Front Regulator
    Exploded View Exploded View 1. Door glass rubber run 2. Front door glass front run ...