S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: P2b96 Injection Pulse

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P2B96

Injection pulse

(Injection Pulse Performance)

Diagnosis condition

—

Signal

—

Threshold

ECM does not control fuel injection quantity properly when engine is running (except engine cold start).

Diagnosis delay time

1 second

POSSIBLE CAUSE

ECM

FAIL-SAFE

Not applicable

Confirmation Procedure

Confirmation Procedure

  1. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start engine and drive the vehicle as per the similar conditions to Freeze Frame Data for 5 seconds. Refer to the table below.

    2. Hold the accelerator pedal as steady as possible.

      CAUTION:

      Always drive Nissan Sentra vehicle in safe manner according to traffic conditions and obey all traffic laws when driving.

      • COOLANT TEMP

      • ENGINE SPEED

      • CAL/LD VALUE

    Is DTC detected?

    YES >>

    Proceed to DTC Diagnosis Procedure.

    NO-1 >>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO-2 >>

    Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. REPLACE ECM

    1. Replace ECM. Refer to ECM : Removal & Installation.

    2. Refer to Work Procedure.

    >>

    INSPECTION END

    P2b95 Cold Start Control
    Dtc Description DTC Description ECM controls fuel injection timing and fuel injection quantity when engine is started with the engine cold. This control promotes the activation ...
    P34ac Electric Intake Valve Timing Control Actuator
    Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P34AC A camshaft posi actuator posi sens B1 (A c...

    Other materials:

    Body Sealing
    Description Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffecte ...

    Torque Converter Clutch Solenoid Circuit
    Diagnosis Procedure Diagnosis Procedure CHECK HARNESS CONNECTOR Ignition switch OFF. Check the mating condition of TCM harness connector and CVT unit harness connector. Is the inspect ...

    Ecu Diagnosis Information. Av Control Unit
    Av Control Unit List of Ecu Reference List of ECU Reference ECU Reference AV control unit Values on the Diagnosis Tool ...