Nissan Sentra B18 (2020-2025) Service Manual: P2812-00 Pressure Control Solenoid G

Nissan Sentra B18 (2020-2025) Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f15a / Dtc/circuit Diagnosis / P2812-00 Pressure Control Solenoid G

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC		CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P2812	00	PC SOLENOID G (Pressure Control Solenoid "G" Control Circuit/Open)	Diagnosis condition	Power supply voltage > 10 V
			Signal	Select solenoid valve drive signal
			Threshold	When solenoid valve drive circuit is diagnosed as open
			Diagnosis delay time	0.2 seconds

POSSIBLE CAUSE

Harness or connector
Select soenoid valve
TCM

FAIL-SAFE

Selector shock is large
Stop/start system prohibited

DTC CONFIRMATION PROCEDURE

PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V.

>>
GO TO 2.
CHECK DTC DETECTION
1. Start the engine.
2. Depress the brake pedal. 3. Shift the selector lever to "R" position and wait for 5 seconds or more.
3. Shift the selector lever to "R" position and wait for 5 seconds or more.
4. Shift the selector lever to "N" position and wait for 5 seconds or more.
5. Shift the selector lever to "D" position and wait for 5 seconds or more.
6. Shift the selector lever to "L" position and wait for 5 seconds or more.
7. Shift the selector lever to "P" position and wait for 5 seconds or more.
8. Check the DTC
Is "P2812-00" detected?
YES >>
Proceed to Diagnosis Procedure.
NO-1>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>
Confirmation after repair: INSPECTION END

Diagnosis Procedure

Diagnosis Procedure

CHECK SELECT SOLENOID VALVE CIRCUIT

Check select solenoid valve circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?
YES >>
Replace TCM. Refer to Removal and Installation.
NO >>
Repair or replace damaged parts.

P2809-00 Pressure Control Solenoid G

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen ter ...

P2814-00 Select Solenoid

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms ( ...

Other materials:

Latch system for children
Exploded View LATCH bracket (RH) LATCH bracket (LH) Seat belt buckle anchor bracket Front Removal and Installation REMOVAL Remove the rear seat cushion assembly. Refer to SE-23, "Removal and Installation - Seat Cushion Assembly" Remove the rear seatback assemb ...

DTC/circuit diagnosis
P1610 LOCK MODE Description ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1610 is displayed with other DTC (for BCM or ...

Precautions
Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner" Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along wit ...