S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: P27b5-00 Control Module

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P27B5

00

CONTROL MODULE

(Internal Control Module Transmission Gear Ratio Control Performance)

Diagnosis condition

When the ignition switch is ON

Signal

—

Threshold

Calculated required torque to increase > Calculated engine torque threshold

Diagnosis delay time

0.27 seconds

POSSIBLE CAUSE

TCM

FAIL-SAFE

Shock at step-shift

DTC CONFIRMATION PROCEDURE

  1. PREPARATION BEFORE WORK

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is more than 10 V.

    >>

    GO TO 2.

  2. CHECK DTC DETECTION

    1. Start the engine.

    2. Drive the Nissan Sentra vehicle and maintain the following conditions for 10 seconds or more.

      Shift position

      : "D" position

      Nissan Sentra Vehicle speed

      : 40 km/h (25 MPH) or more

    3. Stop the Nissan Sentra vehicle.

    4. Check the DTC.

    Is "P27B5-00" detected?

    YES >>

    Proceed to Diagnosis Procedure.

    NO-1>>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO-2>>

    Confirmation after repair: INSPECTION END

Diagnosis Procedure

Diagnosis Procedure

  1. REPLACE TCM

    Replace TCM. Refer to Removal and Installation.

    >>

    WORK END

    P27b3-00 Control Module
    Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P27B3 00 CONTROL MODULE (Internal Control Module...
    P27eb-00 Transmission Range Control a Position Sensor/switch
    Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P27EB 00 T/M RANGE CTRL A POSI SEN/SW (Transmiss...

    Other materials:

    Intelligent Key Battery. Removal and Installation
    Removal and Installation Removal and Installation Release the lock knob at the back of the Intelligent Key and remove the mechanical key. Insert remover tool (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper par ...

    Body Control System. Basic Inspection
    Inspection and Adjustment Additional Service When Replacing Control Unit (bcm) Description Description CAUTION: Be sure to perform the configuration saving and writing or reregistration when replacing the BCM. When replacing the BCM, a ...

    Trip computer
    1. Vehicle speed The vehicle speed screen shows the current speed of the Nissan Sentra as well as the average vehicle speed calculated since the last reset. Average vehicle speed: Press the OK button on the steering wheel to open the drive computer Reset menu, then follow the on-screen in ...