Dtc Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|
P27A4 |
00 |
EL/AUX T/M FLUID PUMP B (Electric/Auxiliary Transmission Fluid Pump "B" Performance/Stuck Off) |
Diagnosis condition |
Diagnosis is permitted when all of the following conditions are satisfied: a) Ignition voltage ≥ 9.01 V b) Battery voltage ≥ 9.01 V c) After ignition on, 1 sec has elapsed. d) Target electric oil pump speed ≥ 500 rpm |
|
Signal |
— |
|||
|
Threshold |
DTC is detected when one of the following conditions "a" and "b" are satisfied: a) Electric oil pump speed ≥ 500 rpm b) Electric oil pump current < 7 A |
|||
|
Diagnosis delay time |
2 seconds |
|||
POSSIBLE CAUSE
Electric oil pump
Control valve
FAIL-SAFE
Stop/start system prohibited
DTC CONFIRMATION PROCEDURE
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V.
>>GO TO 2.
CHECK DTC DETECTION
Ignition switch ON and wait for at 20 seconds.
Check the DTC.
Is "P27A4-00" detected?
YES >>Proceed to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
REPLACE ELECTRIC OIL PUMP
Replace electric oil pump. Refer to Removal and Installation.
>>GO TO 2.
CHECK DTC DETECTION
Perform DTC confirmation procedure. Refer to DTC Description.
Is "P27A4-00" detected again?
YES>>Replace control valve. Refer to Removal and Installation.
NO >>INSPECTION END
P27a3-00 Electric Oil Pump
P27a6-00 Electric Oil PumpP2101 Electric throttle control function
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P2101 is displayed with DTC P2100, first perform the trouble
diagnosis for DTC P2100. Refer
to EC-423, "DTC Logic".
If DTC P2101 is displayed with DTC P2119, first perform the trouble
diagnosis for DTC P2119. Refer
to EC-430, &qu ...
P0101, P0102, P0103 MAF Sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0101
MAF SEN/CIRCUIT-B1
(Mass or volume air flow “A”
circuit range/performance)
An excessively high voltage from the mass ...
Dtc Confirmation Procedure
DTC Confirmation
Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Turn heated seat switch LH (HIGH) ON.
Select “ ...