Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: P0717-00 Input Speed Sensor a

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P0717

00

INPUT SPEED SENSOR A

(Input/Turbine Shaft Speed Sensor "A" Circuit No Signal)

1

Diagnosis condition

Diagnosis is permitted when all of the following conditions are satisfied:

a) Time passed after changing the range > 2 sec

b) Power supply voltage ≥ 10 V

c) Engine speed ≥ 450 rpm

d) Select pressure > 0.15 MPa

e) After ignition ON, the following conditions 'e-1' and 'e-2' are not satisfied even once.

e-1) Input speed ≥ 1000 rpm

e-2) Primary speed ≥ 1000 rpm

Signal

Input speed sensor signal

Threshold

DTC is detected when all of the following conditions are satisfied:

a) Input speed < 150 rpm

b) Primary pulley speed ≥ 500 rpm

Diagnosis delay time

5 seconds

2

Diagnosis condition

Diagnosis is permitted when all of the following conditions are satisfied:

  • Time passed after changing the range > 2 sec

  • Power supply voltage ≥ 10 V

Signal

Input speed sensor signal

Threshold

DTC is detected when all of the following conditions are satisfied:

a) Last input speed ≥ 1000 rpm

b) Current input speed ≤ 240 rpm

Diagnosis delay time

0.5 seconds

POSSIBLE CAUSE

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

  1. PREPARATION BEFORE WORK

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is more than 10 V.

    >>

    GO TO 2.

  2. CHECK DTC DETECTION

    1. Start the engine.

    2. Drive the Nissan Sentra vehicle and maintain the following conditions for 10 seconds or more.

      Shift position

      : "D" position

      Nissan Sentra Vehicle speed

      : 40 km/h (25 MPH) or more

      CAUTION:

      Be careful of the driving speed.

    3. Stop the Nissan Sentra vehicle.

    4. Check the DTC.

    Is "P0717-00" detected?

    YES >>

    Proceed to Diagnosis Procedure.

    NO-1>>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO-2>>

    Confirmation after repair: INSPECTION END

Diagnosis Procedure

Diagnosis Procedure
  1. CHECK DTC PRIORITY

    When DTC "P0717-00" is displayed together with any following DTC, diagnose first the other DTC.

    • P0746-00, P0747-00, P0776-00, P0777-00, P0796-00, P0797-00

    Is applicable DTC detected?

    YES >>

    Perform diagnosis of applicable. DTC Index.

    NO >>

    GO TO 2.

  2. CHECK INPUT SPEED SENSOR CIRCUIT

    Check input speed sensor circuit. Refer to Diagnosis Procedure.

    Is the inspection result normal?

    YES>>

    Replace TCM. Refer to Removal and Installation.

    NO >>

    Repair or replace damaged parts.

P0716-00 Input Speed Sensor a
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms ( ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”, used along with a front seat belt, helps to reduce the risk or severity of injur ...

Bluetooth® settings
To access and adjust the settings for the Bluetooth® Hands-Free Phone System: Press the SETTING button. Use the TUNE/SCROLL knob to select “Bluetooth” and then press the ENTER button: Bluetooth Select “On” or “Off” to turn the vehicle’s Bluetooth® system on or ...

P0011  IVT  control
DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for EC-180, "DTC Logic". DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0011 INT/V TIM CO ...

© 2014-2026 Copyright www.nisentra.com