Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual: P0715-00 Input Speed Sensor a

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P0715

00

INPUT SPEED SENSOR A

(Input/Turbine Shaft Speed Sensor "A" Circuit)

Diagnosis condition

Diagnosis is permitted when all of the following conditions are satisfied:

a) Ignition voltage ≥ 9.01 V

b) Battery voltage ≥ 9.01 V

Signal

Input speed sensor signal

Threshold

DTC is detected when one of the following conditions "a" and "b" are satisfied:

Input speed sensor signal voltage:

a) 4.3 V < sensor signal < 4.5 V

b) 0.1 V < sensor signal < 0.6 V

Diagnosis delay time

0.2 seconds

POSSIBLE CAUSE

  • Harness or connector

  • Input speed sensor

  • TCM

FAIL-SAFE

  • Lock-up is not performed

  • Stop/start system prohibited

DTC CONFIRMATION PROCEDURE

  1. PREPARATION BEFORE WORK

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is more than 10 V.

    >>

    GO TO 2.

  2. CHECK DTC DETECTION

    1. Start the engine.

    2. Drive the Nissan Sentra vehicle and maintain the following conditions for 10 seconds or more.

      Shift position

      : "D" position

      Nissan Sentra Vehicle speed

      : 40 km/h (25 MPH) or more

      CAUTION:

      Be careful of the driving speed.

    3. Stop the Nissan Sentra vehicle.

    4. Check the DTC.

    Is "P0715-00" detected?

    YES >>

    Proceed to Diagnosis Procedure.

    NO-1>>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO-2>>

    Confirmation after repair: INSPECTION END

Diagnosis Procedure

Diagnosis Procedure

  1. CHECK INPUT SPEED SENSOR CIRCUIT

    Check input speed sensor circuit. Refer to Diagnosis Procedure.

    Is the inspection result normal?

    YES>>

    Replace TCM. Refer to Removal and Installation.

    NO >>

    Repair or replace damaged parts.

    P0712-00 Transmission Fluid Temperature Sensor a
    Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0712 00 FLUID TEMP SENSOR A (Transmission Fluid...
    P0716-00 Input Speed Sensor a
    Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0716 00 Input/Turbine shaft speed sensor A (Inp...

    Other materials:

    Diagnosis System (a/c Amp.)
    Diagnosis Description Diagnosis Description CONSULT performs the following functions via CAN communication with A/C amp.: Diagnostic mode CGW Status Descrip ...

    Hill start assist system
    WARNING Never rely solely on the hill start assist system to prevent the Nissan Sentra from rolling backward on an incline. Always drive attentively and maintain control. Depress the brake pedal firmly when stopped on steep hills, especially on icy, snowy, or muddy surfaces. Failure t ...

    Front Suspension. Unit Removal and Installation. Front Suspension Member
    Front Suspension Member Exploded View Exploded View 1. Front suspension member 2. Member stay A. ...