Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / P0402 Egr System

Nissan Sentra B18 (2020-2025) Service Manual: P0402 Egr System

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0402	EGRC-BPT VALVE (EGR A flow excessive detected)	Diagnosis condition	Engine running at idle After engine warmed up
		Signal (terminal)	—
		Threshold	When intake manifold pressure is threshold value or more
		Diagnosis delay time	5 second or more

POSSIBLE CAUSE

EGR volume control valve

FAIL-SAFE

Engine operating condition in fail-safe mode
Fail safe mode		Nissan Sentra Vehicle behavior
Device fix mode		This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position. The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC P0402 is displayed with other DTC, first perform the trouble diagnosis for other DTC.

Is applicable DTC detected?
YES >>
Perform diagnosis of applicable. Refer to DTC Index.
NO >>
GO TO 2.
PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>
GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
1. Start engine and warm it up to normal operating temperature.
2. Shift the selector lever to D range and wait at least for 1 minute at idle speed.
3. Check 1st trip DTC.
Is 1st trip DTC detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P0402 is displayed with other DTC, first perform the trouble diagnosis for other DTC.

Is applicable DTC detected?
YES >>
Perform diagnosis of applicable. Refer to DTC Index.
NO >>
GO TO 2.
CHECK EGR VOLUME CONTROL VALVE VISUALLY
1. Remove the EGR volume control valve. Refer to Removal and Installation.
2. Visually check the EGR volume control valve for cracks and damage.
Is the inspection result normal?
YES >>
INSPECTION END
NO >>
Replace EGR volume control valve. Refer to Removal and Installation.

 P0401 Egr Function

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0401 EGR A FLOW INSUFFICIENT (EGR "A" flow insu...

 P0404 Egr Volume Control Valve

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0404 EGR A CONTROL (EGR “A” Control Circuit...

Other materials:

C1700-86 Control Unit
Dtc Description DTC Description Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure rep ...

Repairing Procedures and Precautions
Fundamentals of Body Repair Fundamentals of Body Repair Fundamentals of Body Repair There are many kinds of damage caused by collisions.Therefore, the appropriate repair method for the damage should be selected. This section outlines repair methods of major damage and how to use ...

Mirrors
Manual anti-glare rearview mirror Use the night position 1 to reduce glare from the headlights of vehicles behind you when driving at night. Select the day position 2 for normal visibility during daylight driving conditions. WARNING Use the night position only when necessary, as it reduces ...