Nissan Sentra B18 (2020-2025) Service Manual: Outside Handle
Removal and Installation
REMOVAL
Fully close rear door glass.
Remove rear door finisher. Refer to Removal and Installation.
Disconnect the harness connector from the rear door lock and release harness clip.
Remove rear door vapor barrier.
Remove rear door rear run screw and bolts and remove rear run rear bracket. Refer to Exploded View.
Remove door
side grommet (1) and loosen bolt from grommet hole.
While
pulling outside handle, remove outside handle escutcheon as
shown.
While
pulling outside handle (1), slide toward rear of Nissan Sentra vehicle to remove
outside handle as shown.
Remove
front gasket (1) and rear gasket (2) as shown.
|
|
:Pawl |
|
|
:Front |
Slide
outside handle bracket toward rear of Nissan Sentra vehicle to remove as
shown.
|
|
:Front |
Disconnect
outside handle cable (1) from outside handle bracket (2) in
sequence shown.
INSTALLATION
Installation in the reverse order of removal.
CAUTION:
-
After installation, check door lock cable is properly engaged to outside handle bracket.
-
After installation, check door open/close and lock/unlock operation.
Inside Handle
Removal and Installation
Removal and Installation
REMOVAL
Remove rear
door finisher. Refer to Removal and Installation.
Remove
screws and door inside handle.
INSTALLATION
In ...
Other materials:
Washer switch
Description
Washer switch is integrated with combination switch (wiper and washer
switch).
Combination switch (wiper and washer switch) supplies ground and fuse #
6 supplies power for the front
washer motor to operate.
Component Inspection
Regarding wiring diagram information, ...
Power Supply and Ground Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK CHASSIS CONTROL MODULE (WITH
BUILT IN STEERING ANGLE SENSOR) IGNITION POWER SUPPLY
Turn the ignition switch OFF.
Disconnect the chassis control module
(with built ...
Commercial Service Tool
Commercial Service Tool
(TechMate No.)
Tool name
Description
(NI-39565)
Engine Ear
...
