Nissan Sentra B18 (2020-2025) Service Manual: Magnet Clutch

Nissan Sentra B18 (2020-2025) Service Manual / Ventilation, Heater & Air Conditioner / Heater & Air Conditioning Control System :: Manual Air Conditioner / Dtc/circuit Diagnosis / Magnet Clutch

Component Function Check

Component Function Check

CHECK MAGNET CLUTCH OPERATION
1. Perform auto active test of IPDM E/R. Refer to CONSULT Function (IPDM E/R).
Does it operate normally?
YES >>
Inspection End.
NO >>
Refer to Diagnosis Procedure.

Diagnosis Procedure

Diagnosis Procedure

CHECK MAGNET CLUTCH POWER SUPPLY CIRCUIT

Disconnect A/C compressor connector and IPDM E/R connector.

Check continuity between A/C compressor harness connector and IPDM E/R harness connector.

A/C compressor		IPDM E/R		Continuity
Connector	Terminal	Connector	Terminal	Continuity
F4	1	F96	65	Yes

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair harness or connector.

CHECK MAGNET CLUTCH GROUND CIRCUIT

Check continuity between A/C compressor harness connector and ground.

A/C compressor		–	Continuity
Connector	Terminal	–	Continuity
F4	2	Ground	Yes

Is the inspection result normal?

YES >>

GO TO 3.

NO >>

Repair harness or connector.

CHECK MAGNET CLUTCH
1. Directly apply battery voltage to the magnet clutch. Check operation visually and by sound.
Does it operate normally?
YES >>
Replace IPDM E/R. Refer to Removal and Installation.
NO >>
Replace magnet clutch. Refer to Removal and Installation.

Blower Motor

Diagnosis Procedure Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check 30A fuse ...

Ecv (electrical Control Valve)

Diagnosis Procedure Diagnosis Procedure CHECK ECV POWER SUPPLY Ignition switch OFF. Di ...

Other materials:

P0365 Exhaust Valve Timing Control Position Sensor
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

Performance test
Inspection INSPECTION PROCEDURE Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. Start the engine, and set to the following condition. Test condition Maintain test condition until A/C system becomes stable. (Approximately 10 minutes) Check t ...

C1716, C1717, C1718, C1719 Transmitter (pressure data)
DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register ...