Nissan Sentra B18 (2020-2025) Service Manual: Intelligent Key Warning Buzzer
Component Function Check
Component Function Check
-
CHECK FUNCTION
-
CONSULT-
Select "OUTSIDE BUZZER" in "Active Test" mode of "HANDS FREE MODULE".
-
Select “On� or “Off� to check that it works normally.
-
Is the inspection result normal?
YES>>Intelligent Key warning buzzer is OK.
NO>>Refer to Diagnosis Procedure.
-
Diagnosis Procedure
Diagnosis Procedure
-
CHECK INTELLIGENT KEY WARNING BUZZER CIRCUIT
-
-
Ignition switch OFF.
-
Disconnect Intelligent Key unit connector and Intelligent Key warning buzzer connector.
-
Check continuity between Intelligent Key unit harness connector and Intelligent Key warning buzzer harness connector.
Intelligent Key unit
Intelligent Key warning buzzer
Continuity
Connector
Terminal
Connector
Terminal
M155
3
E70
1
Yes
-
Check continuity between Intelligent Key unit harness connector and ground.
Intelligent Key unit
—
Continuity
Connector
Terminal
M155
3
Ground
No
-
Is the inspection result normal?
YES >>GO TO 2.
NO >>Repair or replace harness.
-
-
CHECK INTELLIGENT KEY WARNING BUZZER
-
Refer to Component Inspection.
Is the inspection result normal?
YES >>Replace Intelligent Key unit. Refer to Removal and Installation.
NO >>Replace Intelligent Key warning buzzer. Refer to Removal and Installation.
-
Component Inspection
Component Inspection
-
CHECK INTELLIGENT KEY WARNING BUZZER
-
-
Ignition switch OFF.
-
Disconnect Intelligent Key warning buzzer connector.
-
Connect battery power supply directly to Intelligent Key warning buzzer terminals and check the operation.
Intelligent Key warning buzzer
Operation
Terminals
(+)
(−)
1
2
Buzzer sounds
-
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace Intelligent Key warning buzzer. Refer to Removal and Installation.
-
Other materials:
Vehicle-to-vehicle distance control mode limitations
WARNING
Listed below are the system limitations for the Intelligent Cruise Control
(ICC) system. Failure to operate the Nissan Sentra in accordance with these system
limitations could result in serious injury or death.
The ICC system is primarily intended for use on straight, dry, open road ...
Diagnosis System (a/c Amp.)
Diagnosis Description
Diagnosis Description
CONSULT performs the following functions via CAN
communication with A/C amp.:
Diagnostic mode
CGW Status
Descrip ...
Symptom Diagnosis. Push-Button Ignition Switch Does Not Operate
Push-Button Ignition Switch Does Not Operate
Diagnosis Procedure
Diagnosis Procedure
Check that vehicle is under the condition shown
in “Conditions of vehicle� before starting diagnosis, and check each
symptom.
Note:
The engine start function, door lock function,
power dis ...