Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Component Parts /circuit Diagnosis / Intake/exhaust Camshaft Position Sensor

Nissan Sentra B18 (2020-2025) Service Manual: Intake/exhaust Camshaft Position Sensor

Component Inspection

Component Inspection

CHECK CAMSHAFT POSITION SENSOR (PHASE)-1
1. Turn ignition switch OFF.
2. Loosen the fixing bolt of the sensor.
3. Disconnect camshaft position sensor (PHASE) harness connector.
4. Remove the sensor.
5. Visually check the sensor for chipping.
Is the inspection result normal?
YES >>
GO TO 2.
NO >>
Replace camshaft position sensor (PHASE). Refer to Exploded View.

CHECK CAMSHAFT POSITION SENSOR (PHASE)-2

Check resistance camshaft position sensor (PHASE) terminals as follows.

CMP sensor		Condition		Resistance
Terminal		Condition		Resistance
1	2	Temperature	25°C (77°F)	Except 0 Ω
1	3
2	3

Is the inspection result normal?

YES >>

INSPECTION END

NO >>

Replace camshaft position sensor (PHASE). Refer to Exploded View.

 Brake Pedal Position Switch

Component Function Check Component Function Check CHECK BRAKE PEDAL POSITION SWITCH FUNCTION With CONSULT Turn ignition switch ON. Select “BRAKE SW” in “DATA MONITOR” mo...

 Cooling Fan Motor

Component Function Check Component Function Check CHECK COOLING FAN FUNCTION With CONSULT Turn ignition switch ON. Perform “FAN DUTY CONTROL” in “ACTIVE TEST” mode with ...

Other materials:

Before Replacing ECM
SAVE ECM DATA With CONSULT Turn ignition switch OFF. Reconnect all harness connectors disconnected. Turn ignition switch ON. Select “SAVING DATA FOR REPLC ...

Roof. Ecu Diagnosis Information. Moonroof Motor Assembly. Reference Value
Moonroof Motor Assembly. Reference Value Reference Value Reference Value TERMINAL LAYOUT PHYSICAL VALUES Terminal No. (Wire color) Description ...

P2096 A/f Sensor 1
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...