Nissan Sentra B18 (2020-2025) Service Manual: Inspection
INSPECTION AFTER REMOVAL
Check the following items, and replace the parts if necessary.
Transverse Link
-
Check the transverse link for deformation, cracks or damage.
-
Check the bushing for complete separation. (If completely separated, inner metal can be pulled out from transverse link.)
-
Check the ball joint boot for cracks or other damage, and also for grease leaks.
Swing Torque
Move the ball joint at least ten times by hand to check for smooth movement with no binding.
Hook the
Tool (A) on the on ball joint (B). Confirm the measurement value is
within specifications when the ball joint begins moving. 
|
Tool number |
: — (NI-44372) |
|
Swing torque |
: Refer to Ball Joint. |
|
Measurement on spring balance |
: Refer to Ball Joint. |
-
If swing torque exceeds standard range, replace the transverse link.
Axial End Play
Move the ball joint at least ten times by hand to check for smooth movement.
Move the
tip of the ball joint in the axial direction to check for
looseness. Note: 
If there is axial end play, replace transverse link assembly.
INSPECTION AFTER INSTALLATION
Check the neutral position of the steering angle sensor. Refer to Description.
Check the wheel alignment. Refer to Inspection.
Removal and Installation
Removal and Installation
REMOVAL
Remove the
wheel and tire using power tool. Refer to Exploded View.
Remove the
nut and bolt from the lower ball joint. Disconnect the transverse
l ...
Front Stabilizer
...
Other materials:
Exploded View
Exploded View
RH
1.
Front drive shaft
2.
Bearing retainer
3.
Support be ...
Bcm (body Control Module)
List of Ecu Reference
List of ECU Reference
ECU
Reference
BCM
Values on the Diagnosis Tool
...
Chassis Control
Symptom Table
Symptom Table
INTELLIGENT TRACE CONTROL
Perform the “Self Diagnostic Result” using CONSULT
before the symptom diagnosis. Perform the trouble diagnosis if any DTC is
detected. Refer to DTC Index.
...
