Nissan Sentra B18 (2020-2025) Service Manual: Hood Lock Release Cable
Removal and Installation
REMOVAL
Remove fender protector (LH). Refer to Removal and Installation.
Remove hood lock. Refer to Removal and Installation.
Release clips and remove air inlet duct. Refer to Exploded View.
Remove the dash side finisher. Refer to Removal and Installation.
Remove the hood lock release assembly screw.
Disconnect hood lock release cable from hood lock release assembly.
Release hood lock release cable clips using a suitable tool.
Remove grommet on the lower dash and carefully pull the hood lock release cable into the passenger compartment.
CAUTION:
While pulling, be careful not to damage (peel) the outside of hood lock release cable.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Be careful not to bend cable too much, keep the radius 100 mm (3.94 in) or more.
-
Check that cable is not offset from the positioning grommet, and apply the sealant to the grommet (at * mark) properly.
-
Check that hood lock release cable is properly engaged with hood lock.
-
After installation, perform hood adjustment procedure. Refer to Adjustment.
-
After adjusting, perform hood lock inspection. Refer to Inspection.
Hood Lock
Removal and Installation
Removal and Installation
REMOVAL
Remove
front bumper fascia retainer. Refer to Exploded View.
Remove hood
lock bolts.
Disconnect
harness connector ...
Hood Lock Release Assembly
Removal and Installation
Removal and Installation
REMOVAL
Using
suitable tool remove hood lock release handle.
Remove dash
side finisher. Refer to Removal and Installation.
Re ...
Other materials:
P0717-00 Input Speed Sensor a
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
...
Diagnosis and Repair Workflow
Work Flow
Work Flow
OVERALL SEQUENCE
Reference 1··· Refer to CONSULT Function.
Reference 2··· Refer to DTC Index.
Reference 3··· Refer to Symptom Table.
DETAILED FLOW
INTERVIEW AND SYMPTOM
CONFIRMATION
...
Vehicle-to-vehicle distance control mode switches
The Intelligent Cruise Control (ICC) system in the Nissan Sentra is operated
using the ICC master switch together with four dedicated control switches, all conveniently
mounted on the steering wheel for intuitive access while driving.
CANCEL switch: Deactivates the ICC system without era ...
