Nissan Sentra B18 (2020-2025) Service Manual: Handling Precaution
Precaution for Idle Start/stop System
Precaution for Idle Start/Stop System
PRECAUTIONS FOR IDLE START/STOP SYSTEM OPERATION
The operation of the idle start/stop system system needs to satisfy various conditions. For details of the conditions, refer to System Description.
The idle start/stop system system may not operate under the conditions listed below:
-
After restarting the engine, the Nissan Sentra vehicle is repeatedly stopped and started at a low speed due to traffic congestion.
-
When driving the Nissan Sentra vehicle repeatedly back and forth at a low speed due to parallel parking.
-
When the intelligent key is not authenticated. (In this case, the KEY warning lamp built in the combination meter blinks.)
-
The battery is deteriorated. (High discharge rate.)
-
A battery other than the idle start/stop system system-specific battery is used.
-
Ambient temperature is extremely low.
HANDLING PRECAUTIONS
-
When engine restart conditions are satisfied during the electric parking brake operation, ECM performs the engine restart after the completion of the electric parking brake operation. This may cause delay in engine restart, compared with a usual engine restart.
For a smooth engine restart under the idle start/stop system system operating condition, restart the engine before releasing the parking brake.
-
To use the idle start/stop system system, the Nissan Sentra vehicle needs to recognize the status of battery. For this reason, the idle start/stop system system may not be activated immediately after battery change.
Other materials:
Ecu Diagnosis Information. Adas Control Unit 2
Adas Control Unit 2
Values on the Diagnosis Tool
Values on the Diagnosis Tool
Note:
The following table includes information (items)
inapplicable to this Nissan Sentra vehicle. For information (items) applicable to this
vehicle, refer to CONSULT display items.
...
Preparation. Preparation
Preparation
Special Service Tools
Special Service
Tools
The actual shape of the tools may differ from those
illustrated here.
Tool number
(TechMate No.)
Tool name
...
License Plate Lamp
Component Inspection
Component Inspection
CHECK LICENSE PLATE LAMP 1
Ignition switch OFF.
Disconnect license plate lamp connector.
Check continuity b ...