Nissan Sentra B18 (2020-2025) Service Manual: Front Camera
Removal and Installation
REMOVAL
Remove clips (A) and core support
cover (1). 
Remove screws (A) from front bumper
fascia (2). 
Disconnect harness connector from front camera (1) and remove.
INSTALLATION
Installation is in the reverse order of removal.
Note:
Perform "CALIBRATING CAMERA IMAGE (INTELLIGENT AROUND VIEW MONITOR)". Refer to Description.
Around View Monitor Control Unit
Removal and Installation
Removal and Installation
REMOVAL
CAUTION:
When replacing around view monitor control unit,
perform "ADDITIONAL SERVICE WHEN REPLACING AROUND VIEW MONITOR
...
Door Mirror Camera
Removal and Installation
Removal and Installation
REMOVAL
Remove door
mirror cover. Refer to Removal and Installation.
Using a
suitable tool, release pawls from back side of door m ...
Other materials:
Front disc brake
Exploded View
Cap
Bleeder valve
Cylinder body
Piston seal
Piston
Piston boot
Upper sliding pin
Lower sliding pin
Sliding pin boot
Bushing
Torque member
Apply brake fluid
Apply rubber grease
Disassembly and Assembly
DISASSEMBLY
Place a wooden block as shown, and ...
Preparation
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
Commercial Service Tool
...
License lamp finisher
Exploded view
Rear view camera
Trunk lid opener request switch
License lamp finisher
Clip
Pawl
Removal and installation
Remove trunk lid finisher. Refer to INT-45, "Removal and Installation".
Disconnect the harness connector (A) from trunk lid opener
request swit ...
