Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure
-
CHECK BATTERY CURRENT INPUT SIGNAL CIRCUIT
-
-
Ignition switch OFF.
-
Disconnect battery current sensor connector.
-
Check the voltage between battery current sensor harness connector and ground.
(+)
(-)
Voltage
(Approx.)
Battery current sensor
Connector
Terminal
E39
1
Ground
0 V
-
Is the inspection result normal?
YES >>GO TO 2.
NO >>Repair or replace harness.
-
-
CHECK BATTERY CURRENT SENSOR
-
Refer to Component Inspection.
Is the inspection result normal?
YES>>Refer to Intermittent Incident. If the inspection result of the connector is normal then replace IPDM E/R. Refer to Removal and Installation.
NO>>Replace battery current sensor. Refer to Removal and Installation.
-
Confirmation Procedure
Confirmation
Procedure
PERFORM COMPONENT FUNCTION CHECK
CONSULT
Start engine and wait for 10 seconds or more.
...
Component Inspection
Component Inspection
CHECK BATTERY CURRENT SENSOR
Ignition switch OFF.
Reconnect connector w ...
Other materials:
Secondary Speed Sensor Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK HARNESS CONNECTOR - 1
Ignition switch OFF.
Check the mating condition of TCM
harness connector and secondary speed sensor harness
connector.
...
Door Motor Circuit
Diagnosis Procedure
Diagnosis Procedure
Note:
If all of door motor DTCs are detected, check this
circuit.
CHECK DOOR MOTOR POWER SUPPLY
Ignition switch ON.
Check voltage between in ...
Combination meter
Reference Value
VALUES ON THE DIAGNOSIS TOOL
NOTE:
The following table includes information (items) inapplicable to this
vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.
Note:
Some items are not available according to vehicle specificat ...
