Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1

      1. Ignition switch ON.

      2. Check signal between Intelligent Key unit harness connector and ground using oscilloscope.

        (+)

        (–)

        Condition

        Signal

        (Reference value)

        Intelligent Key unit

        Connector

        Terminal

        M155

        37

        Ground

        When the trunk lid opener request switch is operated with push-button ignition switch ON

        When Intelligent Key is in the antenna detection area

        When Intelligent Key is not in the antenna detection area

        38

        When Intelligent Key is in the antenna detection area

        When Intelligent Key is not in the antenna detection area

    Is the inspection result normal?

    YES >>

    Replace Intelligent Key unit. Refer to Removal and Installation.

    NO >>

    GO TO 2.

  2. CHECK OUTSIDE KEY ANTENNA CIRCUIT

      1. Ignition switch OFF.

      2. Disconnect Intelligent Key unit connector and outside key antenna (rear bumper) connector.

      3. Check continuity between Intelligent Key unit harness connector and outside key antenna (rear bumper) harness connector.

        Intelligent Key unit

        Outside key antenna (rear bumper)

        Continuity

        Connector

        Terminal

        Connector

        Terminal

        M155

        37

        B86

        2

        Yes

        38

        1

      4. Check continuity between Intelligent Key unit harness connector and ground.

        Intelligent Key unit

        Continuity

        Connector

        Terminal

        M155

        37

        Ground

        No

        38

    Is the inspection result normal?

    YES >>

    GO TO 3.

    NO >>

    Repair or replace harness.

  3. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2

      1. Replace outside key antenna (rear bumper). (New antenna or other antenna)

      2. Connect Intelligent Key unit and outside key antenna (rear bumper) connector.

      3. Ignition switch ON.

      4. Check signal between Intelligent Key unit harness connector and ground using oscilloscope.

        (+)

        (–)

        Condition

        Signal

        (Reference value)

        Intelligent Key unit

        Connector

        Terminal

        M155

        37

        Ground

        When the trunk lid opener request switch is operated with push-button ignition switch ON

        When Intelligent Key is in the antenna detection area

        When Intelligent Key is not in the antenna detection area

        38

        When Intelligent Key is in the antenna detection area

        When Intelligent Key is not in the antenna detection area

    Is the inspection result normal?

    YES >>

    Replace outside key antenna (rear bumper). Refer to Removal and Installation.

    NO >>

    Replace Intelligent Key unit. Refer to Removal and Installation.

Confirmation Procedure
Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Select “Self Diagnosis Result” mode of “HANDS FREE MODULE" ...

B2046-42 Eeprom
...

Other materials:

Air conditioner system refrigerant and oil recommendations
The air conditioner system in your NISSAN vehicle must be charged with the refrigerant HFC-134a (R-134a) and NISSAN A/C system oil Type S or the exact equivalents. CAUTION The use of any other refrigerant or oil will cause severe damage to the air conditioning system and will require the repl ...

Fuel Injector and Fuel Tube
Exploded View Exploded View 1. High pressure fuel rail 2. Fuel injector assembly 3. ...

C1130 Engine signal
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1130 ENGINE SIGNAL 1 When a malfunction is detected in ECM system. ECM ABS actuator and electric unit (control unit) CAN communication line ...

© 2014-2026 Copyright www.nisentra.com