Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Body Interior / Seat :: Dtc/circuit Diagnosis / B24ba-14 Front Heated Seat Relay Rh (lo) / Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK FUSE

Ignition switch OFF.

Check that the following fuse is not blown (open):

Signal name	Fuse No.	Capacity
Ignition switch ON power supply	6	10 A

Is the inspection result normal?

YES >>

GO TO 2

NO >>

Replace the blown fuse after repairing the affected circuit.

CHECK HEATED SEAT RH LOW RELAY POWER SUPPLY

Disconnect heated seat RH low relay connector.
Ignition switch ON.

Check voltage between heated seat RH low relay harness connector and ground.

(+)	(-)	Voltage (Approx.)
M147	1	Ground	Battery voltage

(+)

(-)

Voltage

(Approx.)

Heated seat RH low relay

Connector

Terminal

M147

Ground

Battery voltage

Is the inspection result normal?

YES >>

GO TO 3.

NO >>

Repair or replace harness.

CHECK HEATED SEAT RH LOW RELAY
1. Check heated seat RH low relay.
  
  Refer to Refer to Component Inspection.
Is the inspection result normal?
YES >>
GO TO 4.
NO >>
Replace heated seat RH low relay.

CHECK HEATED SEAT RH LOW RELAY CONTROL SIGNAL

Connect heated seat RH low relay connector.

Check voltage between A/C auto amp. (with auto A/C) or A/C amp. (with manual A/C) harness connector and ground.

With auto A/C
(+)		(–)	Condition		Voltage (Approx.)
A/C auto amp.
Connector	Terminal
M34	76	Ground	Heated seat switch RH (LOW)	OFF	Battery voltage
M34	76	Ground	Heated seat switch RH (LOW)	ON	0 V

With manual A/C
(+)		(–)	Condition		Voltage (Approx.)
A/C amp.
Connector	Terminal
M82	76	Ground	Heated seat switch RH (LOW)	OFF	Battery voltage
M82	76	Ground	Heated seat switch RH (LOW)	ON	0 V

Is the inspection result normal?

YES >>

Replace A/C auto amp. (with auto A/C) or A/C amp. (with manual A/C). Refer to Removal and Installation (with auto A/C) or Removal and Installation (with manual A/C).

NO >>

GO TO 5.

CHECK HEATED SEAT RH LOW RELAY CONTROL SIGNAL CIRCUIT

Ignition switch OFF.
Disconnect A/C auto amp. connector (with auto A/C) or A/C. amp. connector (with manual A/C) and heated seat RH low relay connector.

Check continuity between A/C auto amp. harness connector (with auto A/C) or A/C. amp. harness connector (with manual A/C) and heated seat RH low relay harness connector.

With auto A/C
A/C auto amp.		Heated seat RH low relay		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M34	76	M147	2	Yes

With manual A/C
A/C amp.		Heated seat RH low relay		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M82	76	M147	2	Yes

Check continuity between A/C auto amp. harness connector (with auto A/C) or A/C amp. harness connector (with manual A/C) and ground.

With auto A/C
A/C auto amp.		(–)	Continuity
Connector	Terminal	(–)	Continuity
M34	76	Ground	No

With manual A/C
A/C amp.		(–)	Continuity
Connector	Terminal	(–)	Continuity
M82	76	Ground	No

Is the inspection result normal?

YES >>

GO TO 6.

NO >>

Repair or replace harness.

CHECK INTERMITTENT INCIDENT
1. Check intermittent incident.
  
  Refer to Intermittent Incident.
>>
Inspection End.

Dtc Confirmation Procedure

DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON. ...

B24bc-12 Front Heated Seat Relay Rh (hi)

...

Other materials:

Starting system (with intelligent key)
Wiring Diagram ...

Chassis Control
Symptom Table Symptom Table INTELLIGENT TRACE CONTROL Perform the “Self Diagnostic Result” using CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Refer to DTC Index. ...

Precautions
Precautions for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner" Precautions for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along w ...