Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C161e-86 Abs System / Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. PERFORM SELF DIAGNOSTIC RESULT

    1. CONSULT

      1. Ignition switch ON.

      2. Select “Self Diagnostic Result” mode of “ABS”.

    Is any DTC detected?

    YES >>

    Check the DTC. Refer to DTC Index.

    NO >>

    GO TO 2.

  2. CHECK CONNECTOR AND TERMINAL

      1. Ignition switch OFF.

      2. Disconnect ABS actuator and electric unit (control unit) harness connector.

      3. Disconnect EPS control unit harness connector.

      4. Check the connector for disconnection or looseness.

      5. Check the pin terminals for damage or loose connection with harness connector.

    Is the inspection result normal?

    YES >>

    GO TO 3.

    NO >>

    Repair or replace harness, connector, or terminal, securely lock the connector.

  3. PERFORM SELF DIAGNOSTIC RESULT

    1. CONSULT

      1. Connect ABS actuator and electric unit (control unit) harness connector.

      2. Connect EPS control unit harness connector.

      3. Ignition switch ON.

      4. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".

      5. Ignition switch OFF and wait for at least 10 seconds.

      6. Ignition switch ON.

      7. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.

    Is DTC “C161E-86” detected?

    YES>>

    EPS control unit is malfunctioning. Replace steering gear column assembly. Refer to Removal and Installation.

    NO>>

    Inspection End.

Confirmation Procedure
Confirmation Procedure PRECONDITIONING If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait ...

U0073-00 Can Comm Circuit
...

Other materials:

Vacuum lines
Exploded View Clamp Vacuum hose (built-in check valve) Vacuum piping Vacuum hose To intake manifold side Paint mark Stamp indicating engine direction To brake booster Removal and Installation REMOVAL Remove air duct and air cleaner case. Refer to EM-25, "Remova ...

Precaution for work
When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a ...

Dtc Confirmation Procedure
DTC Confirmation Procedure DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON. Ignition switch OFF and wait at least 30 seconds. ...

© 2014-2026 Copyright www.nisentra.com