Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure
-
PRECONDITIONING
-
If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
-
-
DTC REPRODUCTION PROCEDURE
-
CONSULT-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
-
Is DTC “C161E-86” detected?
YES >>Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis cont ...
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
...
Other materials:
Removal and Installation
Removal and Installation
Warning:
Before servicing the SRS, place the ignition
switch in the OFF position, disconnect both battery terminals then
wait at least three minutes.
Do not use air tools or electric tools
for servi ...
P0116 ECT Sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0116
ECT SEN/CIRC
(Engine coolant temperature
sensor 1 circuit range/performance)
The comparison result of signals transmitted
t ...
How to Handle Battery
How to Handle Battery
CAUTION:
If it becomes necessary to start the engine with
a booster battery and jumper cables, use a 12-volt booster
battery.
After connecting battery cables, ensure that they
are tightly clamped to ba ...
