Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULT-
Ignition switch OFF to ON.
-
Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
-
Ignition switch OFF and wait for at least 10 seconds.
-
Start the engine.
CAUTION:
Never drive the Nissan Sentra vehicle.
-
Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
-
Is DTC “C1608-54” detected?
YES >>EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO >>Check pin terminal and connection of each harness connector for malfunctioning conditions.
-
Confirmation Procedure
Confirmation Procedure
PRECONDITIONING
If “Confirmation Procedure” has been
previously conducted, always place the ignition switch OFF and wait
...
Other materials:
Warning/Indicator lights (yellow)
For additional details regarding warning and indicator lights, refer to the sections
titled "Vehicle information display 4.2 inch (11 cm) Type A" or "Vehicle information
display 7 inch (18 cm) Type B" in this Owner’s Manual for the Nissan Sentra.
or
Anti-lock Braki ...
Hazard Switch Circuit
Component Function Check
Component Function
Check
CHECK HAZARD SWITCH SIGNAL
CONSULT
Ignition switch ON.
Select “HAZARD SW” in “Data Monitor” mode of “BCM(FLASHER) ...
Symptom diagnosis
Squeak and rattle trouble diagnoses
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
custom ...
