Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1608-54 Control Unit / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start the engine.
    
    CAUTION:
    
    Never drive the Nissan Sentra vehicle.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1608-54” detected?
YES>>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis cont ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure PERFORM SELF DIAGNOSTIC RESULT CONSULT Ignition switch OFF to ON. ...

Other materials:

B142A Ignition voltage
Description DTC B142A IGNITION VOLTAGE Ignition voltage is supplied to the air bag diagnosis sensor unit when the ignition is in the ON position. The air bag diagnosis sensor unit will monitor for low or high ignition voltage. PART LOCATION Refer to SRC-5, "Component Parts Location" ...

Wiper
Consult Function (bcm - Wiper) CONSULT Function (BCM - WIPER) BCM Refer to CONSULT Function (BCM - WIPER). ...

Head Lamp
Consult Function (bcm - Head Lamp) CONSULT Function (BCM - HEAD LAMP) DATA MONITOR Note: The following table includes information (items) inapplicable to this Nissan Sentra vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. ...