Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Suspension / Road Wheels & Tires :: Dtc/circuit Diagnosis / C1741-21 Tire Pressure Sensor No Data Fl / Dtc Diagnosis Procedure

DTC Diagnosis Procedure Note:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs

CHECK TIRE PRESSURE SIGNAL
1. CONSULT
  1. Select "AIR PRESS FL" in "Data Monitor" mode of "BCM(AIR PRESSURE MONITOR)".
  2. Check that the front left tire pressures match the standard value. Refer to Values on the Diagnosis Tool.
    Note:
    BCM holds last tire pressure values during 17 minutes after ignition switch is OFF.
Are all tire pressures displayed 0 kPa (psi)?
YES>>
GO TO 2.
NO>>
GO TO 3.
CHECK BCM POWER SUPPLY CIRCUIT
1. Check BCM power supply circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 3.
NO>>
Repair or replace harness or connectors.
TIRE PRESSURE SENSOR ID REGISTRATION
1. Perform tire pressure sensor ID registration. Refer to Work Procedure.
Can the tire pressure sensor ID registration be completed?
YES>>
GO TO 4.
NO>>
Replace applicable front left tire pressure sensor. Refer to Removal and Installation.
RECHECK TIRE PRESSURE SIGNAL
1. CONSULT
  1. Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more reaches 10 minuets in total.
    Note:
    Avoid driving in areas with radio interference.
  2. Stop the Nissan Sentra vehicle.
  3. Select "AIR PRESS FL" in "Data Monitor" mode of "BCM(AIR PRESSURE MONITOR)".
  4. Check that the front left tire pressures match the standard value. Refer to Values on the Diagnosis Tool.
Is the inspection result normal?
YES>>
After erasing DTC record, Inspection End.
NO>>
Replace BCM. Refer to Removal and Installation.

Dtc Confirmation Procedure

DTC Confirmation Procedure TIRE PRESSURE SENSOR ID REGISTRATION Perform tire pressure sensor ID registration. Refer to Work Procedure. ...

C1742-21 Tire Pressure Sensor No Data Fr

...

Other materials:

Charging system
System Diagram System Description The generator provides DC voltage to operate the vehicle's electrical system and to keep the battery charged. The voltage output is controlled by the IC regulator. Component Description ...

Exhaust valve timing control
EXHAUST VALVE TIMING CONTROL : System Description SYSTEM DIAGRAM INPUT/OUTPUT SIGNAL CHART Sensor Input signal to ECM ECM function Actuator Crankshaft position sensor (POS) Engine speed and piston position Exhaust valve timing control Exhaust valve timing ...

Rear seat
Exploded View Rear seatback assembly (rh) Seatback striker Seatback latch release knob Seatback latch assembly Seatback silencer (RH) Rear seatback frame (rh) Seatback latch release knob finisher Rear seat bolster trim (RH) Rear seat bolster pad (RH) Rear seat bolster (rh) ...