Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure
The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
-
Activate and display TPMS sensor IDs
-
Display tire pressure reported by the TPMS sensor
-
Read TPMS DTCs
-
Register TPMS sensor IDs
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULTReplace front right tire pressure sensor even if other DTCs are displayed along with “C1732-68” in "Self Diagnostic Result" mode of “BCM(AIR PRESSURE MONITOR)”.
Replace front right tire pressure sensor. Refer to Removal and Installation.
-
Dtc Confirmation Procedure
DTC Confirmation
Procedure
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
CAUTION:
...
Other materials:
Predictive Course Line Center Position Adjustment
Description
Description
Adjust the center position of the predictive
course line of the rear view monitor if it is shifted.
Work Procedure
Work Procedure
DRIVING
Drive the vehicle straight ahead 100 m (328.1 ft)
or more at a speed of ...
Work Flow
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine
the conditions that exist when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions
when the noise occurs and any customer's comments; refer to Diagnos ...
Confirmation Procedure
Confirmation Procedure
PRECONDITIONING
If “Confirmation Procedure” has been
previously conducted, always place the ignition switch OFF and wait
at least 10 seconds before conducting the next test.
>&g ...
