Nissan Sentra B18 (2020-2025) Service Manual: Dtc Confirmation Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULT-
Ignition switch ON.
CAUTION:
Never start the engine.
-
Check tire pressure for all wheels and adjust to the specified value. Refer to Tire Air Pressure.
-
Select “Self Diagnostic Result” mode of “BCM(AIR PRESSURE MONITOR)”.
-
Is DTC “C1732-68” detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
-
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
...
Dtc Diagnosis Procedure
DTC Diagnosis
Procedure
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional informatio ...
Other materials:
Diagnosis system (ECM)
Diagnosis description : 1st trip detection
logic and two trip detection logic
When a malfunction is detected for the first time, 1st trip DTC and 1st trip
Freeze Frame data are stored in the
ECM memory. The MIL will not illuminate at this stage. <1st trip>
If the same malfunction is dete ...
Accelerator Pedal Position Sensor
Component Inspection
Component Inspection
CHECK ACCELERATOR PEDAL POSITION
SENSOR
Turn ignition switch OFF.
Reconnect all harness connectors
disconnected.
Turn ignition switch ON.
...
B13cf Buttons
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection condition
...
