Nissan Sentra B18 (2020-2025) Service Manual: Dtc Confirmation Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULTSelect “Self Diagnostic Result” mode of “BCM(AIR PRESSURE MONITOR)”.
Is DTC “C1700-55” detected?
YES >>Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
...
Dtc Diagnosis Procedure
DTC Diagnosis
Procedure
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional informatio ...
Other materials:
Diagnosis Procedure
Diagnosis Procedure
CAUTION:
When performing this inspection, always use a charged
battery that has completed the battery inspection. (When the charging
rate of the battery is low, the response speed of the voltage change
will become slow. This can cause an incorrect in ...
Starter motor drive control
STARTER MOTOR DRIVE CONTROL : System Description
SYSTEN DIAGRAM
*1: CVT models
*2: M/T models
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed
Piston position
Starter ...
Diagnosis Procedure
Diagnosis Procedure
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode
of “EPS/DAST 3”.
...
