Nissan Sentra Service Manual: Dtc/circuit diagnosis

Inspection and adjustment

Additional service when replacing control unit Additional service when replacing control unit : description Memory reset procedure Please observe the following instructions at confirming the moo ...

Power supply and ground circuit

Body control system Body control system : diagnosis procedure Regarding wiring diagram information, refer to bcs-51, "wiring diagram". 1.Check fuses and fusible link Check that the follo ...

Other materials:

P0500 VSS
EXCEPT FOR M/T MODELS EXCEPT FOR M/T MODELS : Description ECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) via the combination unit and the other is from TCM. EXCEPT FOR M/T MODELS : DTC Logi ...

Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO > ...

Front fog lamp
Aiming adjustment PREPARATION BEFORE ADJUSTING The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment procedure, check the following: Ensure all tires are inflated to correct pressure. Place vehicle and screen on level surface. ...