Nissan Sentra manuals

Nissan Sentra Service Manual: Drip molding

Exploded view


  1. Drip molding

Removal and installation Clip


Removal and installation

REMOVAL

Release drip molding clips, then remove drip molding.

INSTALLATION

Installation is in the reverse order of removal.

Roof side molding
Exploded view Roof side molding Roof side molding clip Roof panel Body side outer panel Adhesive tape Removal and installation REMOVAL ROOF SIDE MOLDING Release roof side mol ...

Door sash tape
Exploded view Front door sash upper tape Front door assembly Rear door assembly Front door sash rear tape Rear door sash front tape Rear door sash rear tape Rear door sash upper ta ...

Other materials:

Main line between ipdm-e and dlc circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector e4 Harness connec ...

P0506 ISC System
Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine ...

The seat belt reminder warning continues sounding, or does not sound
Description Seat belt reminder warning does not sound. Seat belt reminder warning sounds continuously. Diagnosis procedure 1.Check seat belt warning lamp Turn ignition switch on. Check the operation of the seat belt warning lamp in the combination meter. Is the inspection ...

В© 2014-2026 Copyright www.nisentra.com