DISASSEMBLY
Loosen
inner socket lock nut (A) and remove outer socket (1).
CAUTION:
To prevent damage, hold outer socket (1) across flats using suitable tool while loosening inner socket lock nut (A).
Remove boot clamps and boot.
CAUTION:
Do not reuse boot clamps or boot.
Remove inner socket.
ASSEMBLY
Apply medium strength thread locker to threads of inner socket. Install inner socket and tighten to specified torque. Refer to Exploded View.
Install
large end of boot (1) to steering gear housing.
CAUTION:
Do not reuse boot.
Apply silicone grease between inner socket and small end of boot.
CAUTION:
To prevent boot deformation or damage during toe-in adjustment, apply silicone grease between inner socket and small end of boot.
Install small end of boot (2) to inner socket boot mounting groove.
Install
small boot clamp (B).
CAUTION:
Do not reuse boot clamps.
Install large boot clamp (A).
CAUTION:
Do not reuse boot clamps.
Install inner socket lock nut and outer socket.
Adjust inner socket (1) to standard length (L), then tighten inner socket lock nut (2) to specification. Refer to Exploded View. Verify inner socket length after tightening lock nut.
|
Inner socket length (L) |
: Refer to Inner Socket Length. |
CAUTION:
To prevent damage, hold outer socket across flats using suitable tool while tightening inner socket lock nut.
Exploded ViewHeadlamp (hi)
Component Inspection
Component Inspection
CHECK HEADLAMP (HI) 1
Ignition switch OFF.
Disconnect front combination lamp connector.
Check continuity be ...
Chassis Control Module (with Built in Steering Angle Sensor)
Dtc Index
DTC Index
Self Diagnostic
Result
DTC
Display item
Refer to
C1B80-54
C ...
Description
Description
If any of the following operations are performed,
the initialization is necessary for normal operation of power window
system:
Disconnection and connection of battery cable from
negative terminal.
When main power window and door lock/unlock ...