Nissan Sentra B18 (2020-2025) Service Manual: Diagnosis and Repair Workflow

Nissan Sentra B18 (2020-2025) Service Manual / Ventilation, Heater & Air Conditioner / Heater & Air Conditioning Control System :: Automatic Air Conditioner / Basic Inspection / Diagnosis and Repair Workflow

Work Flow

Work Flow

OVERALL SEQUENCE

DETAILED FLOW

INTERVIEW CUSTOMER
1. Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred.
>>
GO TO 2.
SYMPTOM CHECK
1. Verify symptoms.
>>
GO TO 3.
CHECK FOR DTCS
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “HVAC”.
  3. Check DTC.
Is any DTC detected?
YES >>
GO TO 4.
NO >>
GO TO 5.
TROULE DIAGNOSIS BY DTC
1. Perform the diagnostic procedure for the detected DTC. Refer to DTC Inspection Priority Chart.
>>
GO TO 7.
OPERATION CHECK
1. Perform the operation check. Refer to Work Procedure.
>>
GO TO 6.
SYMPTOM DIAGNOSIS
1. Check the symptom diagnosis table. Refer to Diagnosis Chart By Symptom.
>>
GO TO 8.
VERIFY REPAIR
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “HVAC”.
  3. Check DTC.
Is any DTC detected?
YES >>
GO TO 4.
NO >>
GO TO 8.
PERFORM FINAL OPERATION CHECK
1. Perform the operation check. Refer to Work Procedure.
Does it operate normally?
YES >>
Inspection End.
NO >>
GO TO 2.

Operation Inspection

Work Procedure Work Procedure DESCRIPTION The purpose of the operational check is to check that the individual system operates normally. ...

Other materials:

P2238 O2 Sensor 1 Bank 1
Dtc Description DTC Description DTC DETECTION LOGIC To judge malfunctions, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal fluctuates according to fuel feedback control. DTC ...

Line Pressure Solenoid Valve Circuit
Diagnosis Procedure Diagnosis Procedure CHECK HARNESS CONNECTOR Ignition switch OFF. Check the mating condition of TCM harness connector and CVT unit harness connector. Is the inspect ...

Interior room lamp
Removal and installation Removal Insert a suitable tool into the gap between the headlining and the interior room lamp and release the interior room lamp. Disconnect the harness connector from the interior room lamp. Installation Installation is in the reverse order of removal. Bul ...