Nissan Sentra Service Manual: Interior room lamp
Removal and installation
Removal
- Insert a suitable tool into the gap between the headlining and the interior room lamp and release the interior room lamp.
- Disconnect the harness connector from the interior room lamp.
Installation
Installation is in the reverse order of removal.
Bulb or lens replacement
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Using a suitable tool, release the pawls and remove the interior room lamp lens from the interior room lamp.
- Remove the interior room lamp bulb.
- Install the interior room lamp bulb to the interior room lamp.
- Install the interior room lamp lens.
Glove box lamp
Removal and installation
Warning:
Do not touch bulb while it is lit or right after being turned off.
Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow ...
Trunk room lamp
Removal and Installation
Warning:
Do not touch bulb while it is lit or right after being turned off.
Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow ...
Other materials:
Precaution for Seat Belt Service
CAUTION:
Before removing the seat belt pre-tensioner assembly, turn the
ignition switch OFF, disconnect both
battery terminals and wait at least three minutes. For approximately three
minutes after the battery
terminals have been removed, it is still possible for the air bag and seat
...
Ecu diagnosis information
Audio unit
Reference value
TERMINAL LAYOUT
PHYSICAL VALUES
1: without BluetoothВ®
2: with BluetoothВ®
BluetoothВ® control unit
Reference value
TERMINAL LAYOUT
PHYSICAL VALUES
...
Instrument panel
Headlight/fog light (if so equipped)/turn
signal switch
Steering wheel switch for trip
computer, audio control and
Bluetooth® Hands-Free Phone System
(if so equipped)
Driver’s supplemental air bag/Horn
Meters and gauges
Cruise control main/set switches
(if so equipped)
...
